Cortelco 730901-TP2-27F - Manual (Page 12)

5
Connecting Your Phone
This section is a reference guide to the basic functions and operations of your cordless
telephone. For more detailed descriptions of the operations and features of this telephone,
refer to the Contents on page 1.
1. Carefully remove your cordless telephone from its shipping carton. If there is any
visible damage, do not attempt to operate this equipment. Return it to the place of
purchase.
2. Check to be sure you have all items that come with this cordless telephone system.
You should have a HANDSET, BASE UNIT, AC ADAPTOR, TELEPHONE LINE
CORD, SHORT TELEPHONE LINE CORD ,BELT CLIP and Owner's Manual.
3. Insert the small plug on the end of the AC ADAPTOR into the POWER-IN CONNEC-
TION JACK at the back of the BASE UNIT.
4. Plug the AC ADAPTOR into a 120V AC wall outlet.
USE ONLY WITH CLASS 2 POWER SOURCE 9V DC,300mA
5. Insert one plug of the TELEPHONE LINE CORD into the house TELEPHONE JACK
and the other end into the TELEPHONE LINE CONNECTION JACK at the back of the
BASE UNIT. (If you have an older 4-prong TELEPHONE JACK, you will need an
RJ-11C TELEPHONE JACK ADAPTOR. This adaptor is available at the same place
you purchased your telephone.)
6. Raise or reposition the ANTENNA on the BASE UNIT for the best reception.
7. We recommend not placing this unit next to appliances, Doing so may cause
interference.
Getting Started
4. Use the dial pad to enter the three digit area code there your phone numbers
begins with.
5. Press and hold down the button.
6. Press the button to return to STANDBY mode.
E. FLASH TIME
This unit enables you to select the standard FLASH TIME applicable to your calling
area. If you are not sure of the FLASH TIME you are using ,call your local telephone
company.
1.Press the button and hold down.
2.Press the TELEPHONE KEYPAD button.
3.Press the button.
4.Press the SCROLL UP or DOWN button to select the FLASH TIME. The
preset FLASH TIME is 600 milliseconds.
5.Press and hold down the button.
6.Press the button to return to STANDBY mode.
F. PAUSE TIME
This unit enables you to adjust the PAUSE TIME when placing a call using a
switchboard system or dialing a Long Distance call.
1. Press the button and hold down.
2. Press the TELEPHONE KEYPAD button.
3. Press the button.
4. Press the SCROLL UP OR DOWN button to adjust the pausing time. The
preset pause time is 4 seconds.
5. Press and hold down the button.
6. Press the button to return to STANDBY mode.
Caller ID System Operation
22
FLASH FLASH EDIT EDIT
DIR DIR RE/PA RE/PA SAVE SAVE
TALK
I N U SE / C H A R G E I N U SE / C H A R G E
2.4GHz
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
SAVE /RE/PA
SAVE /RE/PA
SAVE /RE/PA
EDIT /FLASH
EDIT /FLASH
L D C C F CALLS
AM MIN
NEW PM SEC RPT TOTAL
BATT MSG DIR