Crestron electronic IM-RXV1-M - Manual (Page 19)

Crestron IM-RXV1-M & IM-RXV3-M iMedia Receiver with Video & Mic Input
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Apply power after all connections have been made.
When making connections to the IM-RXV1-M and IM-RXV3-M, consider the
following:
• Use Crestron power supplies for Crestron equipment.
• The included cable cannot be extended.
Hardware Connections (Front, IM-RXV3-M shown)
IM INPUT:
iMEDIA PORT RECEIVERS
AUDIO, VIDEO, AND RGB SIGNALS
AUDIO:
BALANCED OR
UNBALANCED OUTPUT
TO AMPLIFIER
SPEAKER:
AMPLIFIED STEREO
AUDIO OUTPUT
NOTE: For optimum performance, Crestron strongly recommends using
CresCAT-IM cable, available from Crestron. Other high-quality/low skew
CAT5e/CAT6 wiring may also be used with varying performance.
Hardware Connections (Rear)
1 2 3 G
POWER:
FROM POWER SUPPLY
(18 VDC, 3.0 A)
RELAY OUTPUT:
TWO LOW VOLTAGE
CONTACT CLOSURE
RELAYS
DIGITAL INPUTS:
THREE SCHMIDT
TRIGGER TYPE
IR OUTPUT:
TO IRP2
MIC INPUT:
3.5 mm TRS JACK
BALANCED/UNBALANCED
MONO LINE-LEVEL
COMPUTER:
RJ-11 SERIAL PORT
TO LOAD FILES
OR CONSOLE
LAN:
10/100 BASE-T
ETHERNET TO LAN
COM:
BI-DIRECTIONAL RS-232 WITH
HARDWARE AND SOFTWARE
HANDSHAKING AND MODEM CONTROL
COMPOSITE VIDEO OUTPUT:
TO DISPLAY DEVICE
RGB OUTPUT:
TO DISPLAY DEVICE
NOTE: The power supply cable is equipped with a snap lock connector. Always
disconnect the power cable by pulling back on the snap lock of the connector. Never
pull the power cable by the cord.
NOTE: Ensure that the unit is properly grounded.
Operations & Installation Guide – DOC. 6593A iMedia Receiver: IM-RXV1-M & IM-RXV3-M • 15