Craftsman C935.51850 - Manual (Page 5)

ASSEMBLY TOOLS REQUIRED (NOT
SUPPLIED):
- Phillips Screwdriver
ATTACHING THE TWO PIECE
GUARD
WARNING: UNPLUG THE TOOL
BEFORE ATTEMPTING TO ATTACH
THE GUARD. NEVER OPERATE TOOL
WITHOUT GUARD FIRMLY IN PLACE.
THE GUARD MUST ALWAYS BE ON
THE TOOL TO PROTECT THE USER.
• Remove the two guard sections from
the carton.
• Attach the first guard section with side
tab into the groove around the housing
as shown in figure 1. Align the hole in
the guard with the post on the trimmer
housing.
• Remove the screw from the second
guard section.
• Insert the top tab from the second
guard section into the first guard
section as shown in figure 2. NOTE:
The rib behind the tab should be
hooked over the rib of the first guard
section. (See inset figure 2).
• Insert the side tab from the first guard
section into the slot of the second guard
section until you hear them “snap”
together (figure 3).
• Insert the 3/4 inch (19mm) screw as
shown in figure 4 to complete the guard
assembly.
• Once the guard is installed, remove the
covering from the line cut-off blade,
located on the edge of the second guard
section.
ATTACHING THE AUXILIARY
HANDLE
• Attach the handle to the metal shaft of
the trimmer by pushing it onto the shaft
from the side. Once it is pushed onto
the metal shaft, the handle can be
turned into the correct orientation.
• Insert the 2-1/2 inch (63.5mm) bolt
5
4
ASSEMBLY INSTRUCTIONS
1
2
3
Slot
Tab
Tab
Rib
Tab