Harbor Freight Tools Model 97007 - Manual (Page 10)

Page 10 SKU 97007 For technical questions, please call 1-800-444-3353.
opeRating inStRuctionS
Read the entiRe iMpoRtant
SaFety inFoRMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
inspect tool looking for
damaged, loose, and missing
parts before use. if any
problems are found, do not use
tool until repaired.
tool Set up
to pReVent
SeRiouS injuRy
FRoM accidental
opeRation:
turn off and detach the air
supply, safely discharge any
residual air pressure, and
release the Safety paddle
Switch and/or turn the switch
to its off position before
performing any inspection,
maintenance, or cleaning
procedures.
to pReVent SeRiouS
injuRy:
do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. improper
adjustment can result in
tool failure or other serious
hazards.
1. Using the Lock Pin (33) insert into the
side hole of the Collet Holder (24),
and the wrench to turn the Collet Nut
(27), open the Collet so that it can
receive the bit.
2. Place the bit (not included) into the
Collet and use the Lock Pin (33) and
Wrench (34) to secure it firmly.
3. Loosen Thumb Screw (31) and adjust
Guide (29).
Work piece and Work area Set up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2. Route the air hose along a safe route
to reach the work area without creat-
ing a tripping hazard or exposing the
air hose to possible damage. The air
hose must be long enough to reach
the work area with enough extra
length to allow free movement while
working.
3. Secure loose workpieces using a vise
or clamps (not included) to prevent
movement while working.
4. There must not be hazardous ob-
jects, such as utility lines, nearby that
will present a hazard while working.
5. Attach the Rotary Cutting Tool to the
air line and set the air regulator to no
more than 90 PSI.
general operating instructions
1. If an automatic oiler is not used, add
a few drops of Pneumatic Tool Oil
to the airline connection before use.
Add a few drops more after each
hour of continual use.
2. Loosen the Thumb Screw (31) and
adjust the Guide (29) to an appropri-
ate height for the job at hand.
WaRning