CDA HCG 731 - Manual (Page 13)

13
Installation
Technical Information for the Installer
In order to install the hob into the kitchen fixture, a hole with the dimensions shown in fig. 12 has to be
made, bearing in mind the following:
– Within the unit, between the bottom of the hob and the upper surface of a shelf there must be a
clearance of at least 30mm.
– It is absolutely essential that you place a separator between the base of the hob and the built-in unit or
the oven.
– The hob must be kept no less than 200mm away from any side wall (fig. 12).
– The hob must be installed at least 60mm from the wall.
– There must be a distance of at least
650mm between the hob and any
wall cupboard or extractor hood
positioned immediately above (see
fig. 14).
– If the hob is installed over a built-
in oven, there must be a distance
of at least 30mm between the two
appliances. The two appliances should
be connected to the gas supply with
independent connections
650 mm
450 mm
480
60
0
–2
560
200
0
–2
680
500
Installation in Kitchen Cabinet with Door
It is recommended that a 30mm clearance be left
between the cooktop and the fixture surface (fig. 13).
30 mm
Space for
connections
Clearance
Door
Fig. 12
Fig. 14 Fig. 13