Chauvet Q-WASH 360Z-LED - Manual (Page 13)

Operation
Q-Wash 360Z-LED User Manual Rev. 01g -9-
4. Operation
Control Panel
Description
Button Function
<MENU> Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently selected value
in to the current function
<UP>
Navigates upwards through the menu list and increases the numeric value
when in a function
<DOWN>
Navigates downwards through the menu list and decreases the numeric
value when in a function
Control Options You can set the Q-Wash 360Z-LED start address in the 001~512 DMX range. This allows
for the control of up to 34 fixtures in the 15-channel ADVANCED personality.
Programming Refer to the Menu Map on page 14 to learn how the menu options relate to each other.
The menu map has a Menu Level and a variable number of programming levels for each
option.
To go to an option in the Menu Level, press <MENU> repeatedly until the option shows on
the display. Press <ENTER> to select it. This will take you to the first programming level for
that option.
To select an option or value within the current programming level press <UP> or <DOWN>
until it shows on the display. Press <ENTER> to accept it. In this case, if there is another
programming level, you will see its first option. Otherwise, you will see the selected value.
To exit to the previous menu level, press <MENU>.
In the EDIT menu, <UP> and <DOWN> will only change the value of the current
option. To change to the next option, press <ENTER>.
DMX Operation 1) Select DMX operation.
a) Go to MENU > INTRO > RUN.
b) Select DMX512.
2) Select a DMX mode.
a) Go to MENU > INTRO > CHANNELS.
b) Select BASIC or ADVANCED.
3) Select the starting address.
a) Go to MENU > INTRO > ADDRESS.
b) Select a starting address, 001~498 (Advanced) or 001~502 (Basic).
The highest recommended starting address for each of the two DMX modes are as
follows:
BASIC: 502
ADVANCED: 498
Stand-alone
Operation
1) Go to MENU > INTRO > RUN.
2) Select a stand-alone operation mode (AUTO 1, AUTO 2, CUSTOM, or TEST).
Of all the stand-alone operation modes indicated above, only “CUSTOM” is editable
(see Edit Custom).
Continues on the next page