Code Alarm CR3 - Manual (Page 55)

C002332_09_CR3 User Manual - 49 Save Settings
To establish a permanently linked connection between the reader and a CodeXML modem, you must fi rst
scan the Reader ID and Firmware Version code (see below). Verify the modem is connected to the host
and the Blue LED is on. (Note: Verify reader contains a radio by locating the ‘XXXX’ number - see Sec-
tion 4.7. If there is no number indicated, the reader does not contain a radio.)
Prepare the reader to communicate in ‘RF Comm Mode’ by scanning the QuickConnect code on the
paired modem to which you wish to establish a permanent link. Listen for the single beep to verify the
connection acknowledgement. Scan the Lockout Link Mode code (see below). Set appropriate timeout
settings, if applicable (see Section 1.6.5).
To reassign a permanent connection to a different reader, scan the disconnect code or disconnect power
to the linked reader. Using the ‘new’ reader’ follow the directions outlined in the previous paragraph.
To remove Lockout Link Mode between reader and modem simply scan the Unlock Link Mode code (see
following) with the linked reader.
Reader ID and
Firmware Version
Lockout Link Mode Unlock Link Mode
4.11 - Lock-out Link Mode