HP C240 - Manual (Page 145)

127
Changing Your Workstation’s Hardware Configuration
Installing Additional Memory
Perform the following steps to add memory modules to your workstation.
1 Remove the main tray assembly according to the directions in “Removing the
Main Tray Assembly” earlier in this appendix.
2 Use Figure 40 to locate the memory modules on the CPU Assembly.
Figure 40 C160/C180/C200/C240/C360 Memory Module Location
This workstation has 12 memory slots, labeled 0A, 0B through 5A, 5B. The
memory configuration is 32 MB to 1.5 GB installed in pairs of 16 MB, 32 MB,
64 MB, or 128 MB memory modules.
Memory modules must be installed in pairs of equal capacity.
Always install the largest capacity memory modules in the lowest numbered
memory slots.
For example, if you have a pair of 16 MB memory modules and a pair of 64 MB
memory modules, first install the pair of 64 MB memory modules in slots 0A
and 0B, then install the 16 MB modules in slots 1A and 1B.
NOTICE: Memory slots must be filled in order from 0A and 0B through 5A and 5B.
Rear of Main Tray
0A
4A
0B
4B
2A
5A
2B
5B
3A
1A
3B
1B