Clarion DB135 - Manual (Page 6)

8
DB135
English
Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you prefer.
* The factory default setting is “Z-EHCR OFF”.
Each time you press Z-EHCR button 2 , the
tone effect changes in the following order.
“Z-ENHANCER 1”
➜ “Z-ENHANCER 2” ➜
“Z-ENHANCER 3” ➜ “Z-EHCR OFF” ➜
“Z-ENHANCER 1”...
• Z-ENHANCER 1: bass emphasized
• Z-ENHANCER 2: treble emphasized
• Z-ENHANCER 3: bass and treble emphasized
• Z-EHCR OFF: no sound effect
Switching the Clock Display
Press and hold the BND button 4 , and then
press the DISP button 7 to swith between the
operation mode and the clock display.
Setting the Clock
1) Press and hold the BND button 4 , and then
press the DISP button 7 to display the clock
display.
2) Press and hold the BND button 4 , and then
press the DISP button 7 for 2 seconds or
longer.
3) Press the SRCH Up button 8 , then set the
current minute.
4) Press the SRCH Down button 8 , then set
the current hour.
5) Press the BND button 4 , then the clock is
set.
Notes:
• If you select another operation mode while you are
setting the clock, the clock setting operation will be
canceled.
• If you remove the vehicle’s battery for a check or
repair, the clock will be reset, so you must set it again.
Screen Saver mode
1) Press and hold the Band button 4 , and then
press the SS button 9 to switch on, and off
Screen save mode
* The factory default setting is “SS On”.
Radio Mode Operations
FM Reception
For enhanced FM performance the
®
tuner includes signal actuated stereo control and
Multipath noise reduction circuits.
Listening to the Radio
1) Press the FNC button 6 to select the radio
mode, then the radio will be on.
2) To select a preset band, press the BND but-
ton 4 , then select one of the preset bands
such as FM1, FM2, FM3 or AM. Every time
the BND button
4 is pressed, the display will
change as:
3) Press the SRCH Up/Down button 8 , then
the station at which there is a broadcast will
be selected (Seek selection).
Manual Tuning
1) Press the BND button 4 , then select FM1,
FM2, FM3 or AM.
2) Press and hold the BND button 4 for 2 sec-
onds or longer, then the display will show
“MANU”, which means that a manual selec-
tion function is on.
3) Press the SRCH Up/Down button 8 and
select the right station.
Seek Tuning
1) Press the BND button 4 , then select FM1,
FM2, FM3 or AM.
2) If the “MANU” on the display is on, press and
hold the BND button 4 for 2 seconds or
longer. When the “MANU” display is off, the
Seek Selection function is on.
3) Press the SRCH Up/Down button 8 , then
when it selects the station in which there is a
broadcast, it automatically stops.
FM1 FM2 FM3 AM