Clarion M275 - Manual (Page 12)

13
English
M275
Radio Mode Operations
Recalling a preset station
A total of 24 preset positions (6-FM1, 6-FM2,
6-FM3, 6-AM) exists to store individual radio
stations in memory. Pressing the correspond-
ing [DIRECT] button recalls the stored radio fre-
quency automatically.
1. Press the [
BND] button and select the desired
band (FM or AM).
2. Press the corresponding [DIRECT] button to
recall the stored station.
Instant station recall (ISR)
Instant station recall is a special radio preset that
instantly accesses a favorite radio station at a
touch of a button. The ISR function even oper-
ates with the unit in other modes.
ISR memory
1. Select the station that you wish to store in ISR
memory.
2. Press and hold the [ISR] button for 2 seconds
or longer.
Recalling a station with ISR
In any mode, press the [ISR] button to turn on the
radio function and tune the selected radio sta-
tion. “ISR” appears in the display. Press the [ISR]
button again to return to the previous mode.
Area change
Use this function when you are using the boat
stereo anywhere outside the U.S.
Switchable frequency spacing
This boat stereo is initially set to tune in frequen-
cy intervals of 10kHz for AM and 200 kHz for FM,
the standard calibrations in U.S. When using the
unit outside the U.S., use the following procedure
to switch the frequency range.
The table below lists the frequency specifications
for the U.S. and other countries.
Initial
Setting
(U.S.
standard)
New
Setting
(Third
Area/
Australia
standard)
New
Setting
(Europe
standard)
AM
FM
Frequency
Spacing
Frequency
Range
Frequency
Spacing
Frequency
Range
10 kHz 9 kHz 9 kHz
530 to
1710 kHz
531 to
1629 kHz
531 to
1602 kHz
200 kHz 50 kHz 50 kHz
87.9 to
107.9 MHz
87.0 to
108 MHz
87.5 to
108 MHz
Switching the area change
Inside U.S. standard (Initial Setting)
While pressing the [ ] button, press the [SCN]
button, then “U.S. standard” will be selected.
Third Area/Australia standard (New Set-
ting)
While pressing the [ ] button, press the [RPT]
button, then “Third Area/Australia standard”
will be selected.
Europe standard (New Setting)
While pressing the [ ] button, press the [RDM]
button, then “Europe standard” will be select-
ed.