Verykool i277 - Manual (Page 25)

equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
THIS MOBILE PHONE MEETS THE INTERNATIONAL RECOMMENDATIONS
FOR EXPOSURE TO
RADIO WAVES
Your mobile phone is a radio transmitter and receiver. It is designed and manufactured
not to exceed the limits for exposure to radio frequency (RF) energy defined by the
international standards. These recommendations have been established by the
International Commission on Non-Ionizing Radiation Protection (ICNIRP) and, the
Institute of Electrical and Electronics Engineers (IEEE) that forecast a substantial
safety margin for assuring the protection of all persons, regardless of age and health.
The exposure recommendations for mobile phones use a measurement unit known as
the Specific Absorption Rate (SAR). The SAR limit recommended by the ICNIRP for
the mobile phones used by the general public is 2.0W/kg averaged over ten grams of
tissue and, is 1,6W/kg averaged over one gram of tissue by IEEE Std 1528 for the
head.
Tests for SAR have been conducted using recommended operating positions with the
mobile phone transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power level, the actual
SAR levels of the mobile phone while operating are generally below the maximum
SAR value. This is because the phone is designed to operate at multiple power levels
so as to use only the power required to reach the network. In general, the closer you
are to a base station antenna, the lower the power output.
While there may be differences between the SAR levels of various phones and at
various positions, they all meet the international protection standards for exposure to
- 25 -