Clarion MS2106 - Manual (Page 12)

12
7. Remote Start in Valet Mode: Selects whether or not the remote start can be
activated when the security system is in Valet mode. (Requires optional Ungo-
Net remote start module.)
8. Automatic Starting: Selects whether or not the Ungo-Net start module can be
programmed for automatic starting. If selected, the Ungo-Net start module can
be set to automatically start the vehicle in extreme cold weather or when low
battery voltage is detected. (Requires optional Ungo-Net remote start module.)
4.2 Entering User Programming
To change any of the user programmable options, follow the steps below:
1. Turn the ignition ON.
2. Within 5 seconds, press the Valet/Override button 2 times and hold for 2
seconds.
• The siren will chirp, indicating that User Programming has been entered.
3. Press the Valet/Override button the number of times equal to the Option to be
changed.
• The siren will chirp each time the Valet/Override button is pressed.
4. Within 5 seconds, press the transmitter button corresponding to the desired
operating mode for that Option.
• The siren will chirp a number of times equal to the transmitter button pressed.
5. When finished, turn the ignition OFF to save changes.
4.3 Default Reset for User Programming
The user programmable options may be restored to the factory default setting at
any time. To restore the factory defaults follow the steps below:
1. Turn the ignition ON.
2. Within 5 seconds, press the Valet/Override button 2 times and hold for 2
seconds.
• The siren will chirp, indicating that Programming has been entered.
3. Press transmitter button 3.
• The siren will chirp 6 times indicating the reset signal has been received, and
User Options have been reset to factory default.
MS2106 owner 7-14.qxd 7/14/2003 1:43 PM Page 12