Clarion MS2106 - Manual (Page 8)

8
3.10 Remote Panic Feature
In the event of an emergency (PANIC) situation, the system's siren can be triggered
for 45 seconds to attract attention. To activate the Panic feature, press and hold
the Lock button for 3 seconds.
• The siren will sound.
• The parking lights will flash.*
• The doors will unlock.*
• The starter disable will turn Off.*
* Optional feature
3.11 Coded Emergency Override (Programmable feature)
If the remote transmitter becomes lost or fails to operate, use the emergency
override feature to disarm the alarm system. Be sure that you have your ignition
keys ready and that you know the location of the Override switch before you
perform this procedure.
To override the system:
1. Enter the vehicle.
• Because the alarm system is armed, the siren will sound.
2. Turn the ignition On.
3. Press the Override switch a number of times equal to the disarm code and
continue holding for 10 seconds on the last press. (If the default code setting
has not been changed, press and hold the override switch for 10 seconds to
disarm to system.)
• The system will disarm.
• The siren will stop sounding.
• Starter disable will turn Off.
4. You can now start and drive the car.
5. If the disarm code is not entered correctly, turn off the ignition and begin again
at step 2.
6. Consult your authorized Ungo dealer to check the alarm system.
The default setting for the Emergency Override Disarm Code is 1. To change the
Emergency Override Code see User Selectable Programming Options, step 6.
Note: During installation, your installer can program the system to give a 15 second
entry delay when the system Arms passively. When the door is opened after the
system is Armed, the siren will give a series warning of chirps before sounding,
giving you time to perform the emergency override procedure.
MS2106 owner 7-14.qxd 7/14/2003 1:42 PM Page 8