Concord Camera 4360Z - Manual (Page 7)

6
GETTING STARTED
En
TURNING THE CAMERA ON AND OFF
The Power Button is located on the top of the camera.( fig.1.1)
1. Press the ( ) Power Button to turn the camera on.
• The lens cover will open, and the lens will extend out automatically to the
wide-angle position.
• The LCD will turn on automatically.
2. To turn the camera off, press the ( ) Power Button.
Note:
To extend battery life, the LCD will turn off after 1 minute of inactivity, press the ( ) button, the Shutter
Button or the Power Button to reactivate the LCD. The camera will automatically power off after 2 minutes
of inactivity, press the Power Button to power the camera back on.
Checking the Battery Level
There are 5 battery levels that are displayed on the LCD.
Note:
• The camera's battery level indicator may not accurately reflect the state of a rechargeable battery even
the chargeable batteries have been fully recharged.
• To extend battery life, the camera will automatically power off after 2 minutes of inactivity. To change this
setting, please refer to p.33.
• For better performance, please use NiMH rechargeable batteries.
• Remove the batteries from the camera if they will not be used for an extended period of time to prevent
corrosion or battery leaks.
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
fig.1.1
Batteries are full
and ready to use.
3/4 battery
capacity remains.
1/2 battery
capacity remains.
1/4 battery
capacity remains.
Batteries are low
need to be
replaced soon.
Batteries are
empty, blinking
red and need to
be replaced.
DZ4360 UGuide-E(512883-01) 2003:11:17 5:22 PM Page 6