Keri Systems EntraGuard Bronze Residence Guide - Manual (Page 7)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-003 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 7 of 14
Telephone Entry
Residence Guide
2.1.3 Exiting Programming Mode
When programming from the EntraGuard Bronze unit, the unit exits programming mode after 1
minute of keypad inactivity. To exit programming mode immediately after entering a programming
command, press .
To exit programming mode when using the residence telephone, press or simply hang up.
2.2 Set Programming Mode Entry Code
To increase system security, you have the option to change the code number required to enter
programming mode from its pre-programmed setting.
NOTE: To ensure the security of your EntraGuard Bronze system, Keri Systems strongly
recommends that you perform this command at any time you feel the Programming Code has been
discovered by someone who should not have it.
This code number must be six-digits long. For security reasons, certain consecutive strings of
numbers are not accepted; for example, “123456” is not accepted. Perform the following to set the
programming mode entry code.
1. Press .
2. Enter the desired six-digit programming mode entry code – .
3. Press to lock in the new programming mode entry code. The unit emits a short, high-
pitched tone to indicate the new code has been accepted. The unit emits a short, high-pitched
tone followed by a low-pitched tone if the programming mode entry code has been rejected.
EXAMPLE: Enter the following to set a Programming Mode Entry Code of “135246.”
4. You can now enter another program command or press to exit programming mode.