KERN & SOHN ABJ 320-4NM - Manual (Page 50)

50 ABS-N_ABJ-NM-BA -e-1312
12.2 Auto zero function
The auto zero function is not available when formula mode is enabled
(see chapter 14.3).
1. Call up menu
 Press TARE for 3 sec. in weighing mode.

2. Select function
 Press the navigation buttons ( ) repeatedly until
„A.ZERO“ is displayed. The current setting is marked by
the stability display ( ).
Further steps depend on the desired setting:
Stability
display (
)
Function set/update cancel
yes
ON
 Press PRINT and
continue with step 3.
Press TARE and
continue with step 4.
no
off
 Press TARE and
continue with step 3.
continue with step 4.
3. Define zero range
 Press TARE
 Use the navigation keys ( ) to enter the zero range
see chpt. 3.1.1 „Numeric input“.
4. Return to weighing mode
 Press ON/OFF repeatedly or for 3 sec.
When entering the zero range observe the currently set weighing unit.
If the weighing unit is changed at a later moment, the zero range must be
adapted to the new weighing unit (step 3.).
Upper limit zero range: 99 d (in the displayed weighing unit)
Lower limit zero range: 1d (in the displayed weighing unit)
Example for a balance d = 0.0001 g
Unit Lower limit Upper limit
g 0.0001 g 0.0099 g
ct 0.001 ct 0.099 ct