KERN & SOHN ABJ 320-4NM - Manual (Page 72)

72 ABS-N_ABJ-NM-BA -e-1312
15.2 Target mode
This mode e.g. is used for weighing constant liquid quantities or for assessment of
missing quantities or excess quantities.
The target value is the numeric value which corresponds to the nominal quantity of
the used unit. Beside the target value a tolerance value is entered. This is a
numerical value which is plus/minus over or under the acceptable target value.
The indicators
,
or advise, when the target value is reached.
These indicators are only functioning in check weighing or in target mode, otherwise
they cannot be seen.
The indicators provide the following information:
Condition Grading Indicator
Weight more than the nominal
weight and above the upper
tolerance
Great difference to target value
flashes slowly
Small difference to target value
flashes fast
Weight within tolerance
(target value ± tolerance)
Target value accepted
Weight less than nominal
weight and below the lower
tolerance
Small difference to target value
flashes fast
Great difference to target value
flashes fast