KERN & SOHN VFS 2T1 Addendum - Manual (Page 18)

EPM205 - Technical reference - Rev. A Page 18
Advanced Printing Systems
8. MECHANICAL & HOUSING
8.1. Overall dimensions and fixing points
See attached drawings for overall dimensions and recommended screws.
3D-IGES file, for mechanical details, is available upon request, ask APS for more information.
The mechanism has to be fixed using the fixing points provided for this purpose.
There are two possibilities:
· Using points 1-2-4-5 (all of them simultaneously).
· Using points 3-4-5 (all of them simultaneously).
To avoid any kind of deformation or distortion, a flat surface for contact areas is required, if not, the print
quality and printer's life will be drastically reduced.
Points 3-4-5 are on the same plane, at the mounting base of the EPM.
Points 1-2 are on the same plane and have a 19.2mm distance from the mounting base plane (see also
attached drawing).
The image below, shows the matching areas to be used for fixing, they are highlighted in red colour.
Bottom view of EPM205
1 2
3
4 5