KERN & SOHN TN 60-0.01EE - Manual (Page 12)

12 TN_EE-BA-e-1410
When the scan mode is turned off, the single point mode will be automatically turned
on. Turn on/off the scan mode by the following steps:
Press the
key to switch the scan mode on and off. It will display the current condi-
tion of the scan mode on the main screen.
4.7 Changing Resolution
The gauge has selectable display resolution, which is 0.1mm and 0.01mm.
Press down the key while turning on the gauge will switch the resolution between
“High” and “Low”.
4.8 Changing Units
On the measurement mode, press the key to switch back and forth between impe-
rial and metric units.
4.9 Memory Management
4.9.1 Storing a reading
There are twenty files (F00-F19) that can be used to store the measurement values
inside the gauge. At most 100 records (thickness values) can be stored to each file.
By simply pressing the
key after a new measurement reading appears, the meas-
ured thickness value will be saved to current file. It is added as the last record of the
file. To change the destination file to store the measured values, follow the steps:
1) Press the
key to activate the data logging functions. It will display the current
file name and the total record count of the file.
2) Use the key and the key to select the desired file to set as current file.
3) Press the key to exit the data logging functions at any time.
4.9.2 Clearing selected file
The user may require the contents of an entire file be completely cleared of all meas-
urements. This would allow the user to start a new list of measurements starting at
storage location L00. The procedure is outlined in the following steps.
1. Press the
key to activate the data logging functions. It will display the current
file name and the total record count of the file.
2. Use the key and the key to scroll to the file that will be cleared of all meas-
urements.
3. Press the key on the desired file. It will automatically clear the file, and display
“-DEL”.
4. Press the key, at any time, to exit the data logging functions and return to
measurement mode.
4.9.3 Viewing/deleting stored record
This function provides the user with the ability to view/delete a record in a desired file
previously saved in memory. Following is the steps:
1. Press the
key to activate the data logging functions. It will display the current
file name and the total record count of the file.
2. Use the key and the key to select the desired file.