10 el backlight, 11 battery information, 12 auto power off – KERN & SOHN TN 60-0.01EE User Manual

Page 13: 13 system reset, 14 connecting to a computer, 5 servicing

Advertising
background image

TN_EE-BA-e-1410

13

3. Press the

key to enter the selected file. It will display the current record num-

ber (for example, L012) and the record content.

4. Use the

key and the

key to select the desired record.

5. Press the

key on the desired record. It will automatically delete this record,

and display “-DEL”.

6. Press the key to exit the data logging functions and return to measurement

mode.

4.10 EL Backlight


With the background light, it is convenient to work in the dark condition. Press key

to switch on or switch off the background light at any moment as you need after pow-
er on. Since the EL light will consume much power, turn on it only when necessary.

4.11 Battery Information


Two AA size alkaline batteries are needed as the power source. After several hours’
usage of the preset batteries, the battery symbol on the screen will be shown as

. The more of dark part indicates the more close to fill. When the battery ca-

pacity runs out, the battery symbol will be shown as

and will begin to flash.

When this occurs, the batteries should be replaced.
Please take out the batteries when not working during a long period of time.

4.12 Auto Power Off


The instrument features an auto power off function designed to conserve battery life.
If the tool is idle for 5 minutes, it will turn itself off. While the voltage of the battery is
too low this function will also work.

4.13 System Reset


Press down the

key while powering on the instrument will restore factory defaults.

All the memory data will be cleared during system reset. The only time this might
possibly helpful is if the parameter in the gauge was somehow corrupted.

4.14 Connecting to a Computer


The gauge is equipped with a USB port. Using the accessory cable, the gauge has
the ability to be connected to a computer, or external storage device. Measurement
data stored in the memory of the gauge can be transferred to the computer through
the USB port. Detailed information of the communication software and its usage refer
to the software manual.

5 Servicing


When the tester appears some other abnormal phenomena, please do not dismantle
or adjust any fixed assembled parts. Just contact us by e-mail or phone and the fol-
low-up for a (warranty) service can be initiated.

Advertising
This manual is related to the following products: