KGUARD Security BR1621 - Manual (Page 54)

ENGLISH
Chapter 4: Using the DVR
54
DVR User’s Manual
5
Specify the Client Port and HTTP Port numbers.
• Client Port: Specify the port number that the device will use to send DVR command and video stream.
• HTTP Port: Specify the port number that you will use to log in to the device.
Note:
• Obtain these information from your network administrator or your Internet Service Provider (ISP).
• If you cannot use the either of the two default ports, 80 or 9000, the specified port may be occupied by other
programs or it is being blocked by your service provider. Enter other port number. In this case, you need to
add the port number after the IP address. For example, if you set the HTTP Port as 85, you need to enter the
IP address as “192.168.3.103:85”.
6
Enter other parameter settings (if applicable).
• If your network connection is Static, specify the static IP address, Subnet Mask, Gateway, and DNS 1/DNS 2 IP
addresses.
• If your network connection is PPPoE, enter the User Name and Password that you setup with your DSL service
provider. Then, specify the DNS 1/DNS 2 IP addresses.
Note:
The system supports two DNS server input options: DNS Server1 for main server and DNS Server2 for sub server.
Please contact your local ISP (Internet Service Provider) to obtain the correct DNS Server parameter.
7
To enable Auto Port Forwarding (UPNP) feature, select Enable.
Note:
Not all routers support the Auto Port Forwarding feature. If this function does not work, you must manually open
the ports in your router.
8
After all settings are complete, click Apply.
9
When data saving is complete, click OK.