Kuzma Stabi - Manual (Page 14)

_________________________________________________________________
S T A B I T U R N T A B L E 14 KUZMA
7. Mounting of Tonearm
a) To cut blank mounting board
i) Use template provided by manufacturer and mark position of cuts. Bear in mind
that there must be adequate space to close lid and for counterweight. Also check
position of tonearm output cable.
ii) Unscrew four screws securing mounting board using Alan key provided (No. 5)
iii) Make cuts on board. Note that board is of medite which is easy to cut.
iv) Fix tonearm base to board as instructed and replace mounting board, tightening
screws with Alan key.
With pre-cut board
If board is pre-cut it may still be convenient to remove board to attach tonearm base
(see ii and iv above) though this is not always necessary.
b) Fix tonearm into arm base.
c) The weight of the tonearm will have altered the height of the platter from the
turntable top.This should be readjusted using the four black knobs to regain the
required height between platter and top plate of 2 - 3 mm. Ensure that the height
is even around the circumference of the platter (Figs. 6 and 7)
NOTE: Anticlockwise lowers platter, clockwise raises.
d) Securing tonearm cable
You will need a large screwdriver.
i) Close lid and detatch power supply.
ii) Position turntable so that right rear corner extends well over table edge (back leg
should extend over edge). (Fig. 11)
iii) There are two fixing points for the cable, one on the subchassis A. and the other
on frame near rear leg B. Secure cable in curve between these two points.
Ensure
that there is adequate cable from tonearm to allow for height adjustment of
tonearm. (Fig. 12)