Kuzma Stabi - Manual (Page 9)

_________________________________________________________________
S T A B I T U R N T A B L E 9 KUZMA
2. Oil in Bearing and Insertion of Subplatter
a) Remove tape sealing bearing.
b) Take smaller oil bottle and squeeze 20 drops into the bearing in centre of
turntable. The insertion of the shaft will cause the oil level to rise.
c) Remove protective plastic tube from subplatter shaft. Handle carefully and
ensure no dust adheres to shaft.
NOTE: Should any dirt become attached, wipe with cotton cloth and alcohol.
d) Slowly insert flat ended shaft into bearing.
e) Rotate subplatter to ensure smooth movement.
f) Lift out subplatter and check that level of oil on shaft reaches the top. If level
is lower add oil drops, approximately one drop to increase level for one mm.
Oil should bathe shaft completely. To check this see Fig. 5.
Fig. 5
NOTE: The shaft is not tight in bearing and will rock slightly if pressed.
3. Belt
This can be found with subplatter.
a) Ensure hands are clean and dry and remove belt from plastic bag.
b) Place belt around subplatter and then around top groove of motor pulley.
NOTE: Subplatter is higher than motor pulley as weight of platter has yet to be
added.
NOTE: When putting belt around subplatter it may slip and drop under subplatter.
If so it is important to check that no oil has adhered to belt and if necessary
to clean belt with cotton cloth and alcohol.