LAARS SUMMIT SMB-250 - Users Manual - Manual (Page 3)

SUMMIT Page 3
4. This appliance is equipped with an ignition
device which automatically lights the burner.
Do not try to light the burner by hand.
5. Remove front cover.
6. Turn gas shutoff valve to “off”. Handle will be
aligned across gas pipe. Do not force.
7. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow “B” in the
safety information above on this label. If you
don't smell gas, go to next step.
8. Turn gas shutoff valve to “on”. Handle will be
aligned along gas pipe.
9. Turn on all electric power to appliance,
depress on/off button on control panel,
depress black button on top of control panel.
10. Replace front cover.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance”
and call your service technician or gas
supplier.
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING
If you do not follow these instructions exactly, a fire or explosion
may result, causing property damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burner. Do not try to
light the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
C. Turn off gas shutoff valve (located above the
combination gas control) so that the handle
is aligned across the gas pipe. If the handle
will not turn by hand, don't try to repair it, call
a qualified service technician. Force or
attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part may
have been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
may have been under water.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above on
this label.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
3. Remove front cover.
4. Turn gas shutoff valve “off”. Handle will be
aligned across gas pipe. Do not force.
5. Replace front cover.
H2013100A