Leapers 2.6 ITA Red/Green CQB Micro Dot with Integral QD Mount (SCP-DS3026W) - Manual (Page 18)

16 II. For Zero Deaklock Turrets, use a flat head
screwdriver to adjust the
windage and elevation as
shown in Fig. 10. Refer to
the ZEROING section for
further steps.
4. OPTIONAL ZERO LOCKING –
Once the scope is zeroed, you
can use the Allen wrench to lock down the turrets for most
repeatable shooting performance.
I. To lock Double Lock
Turrets: Use the included
small Allen wrench to fully
lock down both screws by
turning them clockwise
as shown in Fig. 11. It is
recommended that you
gradually lock both screws
alternately until they are
fully and evenly locked.
Fig 10
Fig 11
Fig 12