Levana ERA - Manual (Page 12)

12
SETTING UP YOUR SYSTEM
Placement of the Parent unit
This parent unit can be placed on a tabletop or you can also carry it on
your belt.
1. You can place the parent unit on a tabletop by using the retractable,
stainless-steel table stand on the back of the parent unit. When not in
use, simply tuck table stand away into the back of the parent unit.
2. You can also carry the parent unit on your belt by using the integrated
belt clip on the back of the parent unit and sliding the clip over
your belt.
Charging the Battery
1. Connect the small end into the DC Jack on the side of the parent unit
as shown in the diagram, connect the other end of the adapter into an
available wall outlet.
2. The icon in the top right corner of the main screen will show you the
battery power status.
3. For safety reasons, ONLY use the adapters included in
the package.
Note: Baby monitors and cameras with power cords should never be hung on or near the crib as it is a
strangulation hazard. Power cords should be kept no less than 3 feet away from the crib and the baby’s
reach at all times.
Removeable
Belt clip
Table stand
Battery
Charging
Battery
Full
Battery
Empty
Two
Bars
One
Bar
ENGLISH