Lippert Components 07-10 Tundra Camper Tiedowns - Manual

Step 2 – Remove existing bolts attaching cable clamps to
the frame at the locations shown below.
(Save bolts, they will be reinstalled later)
Driver
Side
Passenger
Side
Be sure to connect proper end to bracket This is the end
with the sharper bend and only 1 nut at the end of the
threaded rod section. Use the ½” long fine thread bolt
supplied in the hardware kit..
3 – Clip the positioning tabs from the ends of the cable
brackets with a pair of dikes or tin snips.
Positioning
Tabs
4. Set tie down bracket in place and install upper bolt. Place
the tie down bracket between the cable bracket and frame
and reinsert the bolt previously removed from this location.
Frame
Tie down
Bracket
Drivers Side
Shown
4.a – On the passenger side, use a 1” bolt, washer, lock washer
& nut through the existing hole in the frame at this location.
5. Ensure that the bracket is sitting snug to the corner and
straight then drill lower
mounting hole through
frame extension
as shown. Note it may
be necessary to clamp
the bracket in place
while drilling.
Use 13/32 drill bit.
Step 1 – Install the support brace to the bracket
as shown below. Snug, but do not tighten,
brace will be positioned later.
Drivers side shown
FRONT ANCHORS
07-10 TUNDRA
CAMPER TIEDOWNS
Drivers side
Passenger side