Lippert Components 07-10 Tundra Camper Tiedowns - Manual (Page 2)

6. Position the frame end of the support brace between the
frame and the cable bracket removed in step 2 then
reinstall the cable bracket bolt.
Cab Bed
Passenger Side Shown
NOTE: It may be necessary
to loosen the jam nut on the
threaded portion of the
support brace and lengthen
or shorten the brace until
the hole in the brace lines
up with the hole in the
frame.
8. Once the front anchors and support brace are installed
and tightened in place, the support brace can be
adjusted for best fit. Loosen the jam nut and turn the
adjusting nut at the opposite end of the treaded portion
to lengthen or shorten the support brace.
Jam Nut
Adjusting
Nut
3/16” -1/4”
clearance
at closest
point
8. Adjust support brace to the clearance shown below
then tighten Jam Nut.
7. Tighten all hardware (do not over tighten and strip).
This completes the front anchor installation
REAR ANCHORS
Anchor
Plate
Flat edges of Anchor Bolt
must be horizontal.
NOTE: Rear anchors are installed in the end of the bumper.
here is no precise mounting location since a variety of bumpers
may be installed. The general guidelines are as follows:
1. Mounting location should be as flat & vertical as possible.
2. Be sure no moldings or bumper caps interfere with
the removable coupler.
3. Check back side of selected mounting location to ensure
adequate access for tightening nut.
4. Choose a location approx.2/3 back from the front edge
of the bumper. Center punch and drill a small pilot hole, then
enlarge to 1 / 2 ”.
5. Install Anchor Bolt with 2” fender washer, lock washer & nut.