Liberty Garden 880 - Manual (Page 5)

5
Model 880 not shown in Figure 11
FIGURE 11
FIGURE 8
FIGURE 9
FIGURE 10
8. Attach wheels (G) by removing nuts on axle. Slide axle
(F) thru the frame (B). Before adding wheels (G) slide the
plastic spacers (N) thru both ends of the axle (F) Slide on
wheels (G) and tighten nuts on each end.
See Figure 8.
9. Attach basket (E) using handle bolts (P) and
fasten with wing nuts (Q) to the U-handle (C). Slide
the U-handle (C) over the frame extensions and
align the holes. Insert handle bolts (P) through the
holes in the U-handle and fasten with wing nuts (Q)
Hand tighten. See Figure 9
10. Attach the leader hose (D) to the end of the
brass swivel (L). DO NOT OVER TIGHTEN.
See Figure 10
11.Attaching your garden hose: Attach your hose
to the galvanized tee. Loop the hose over the
spool end to avoid kinking. See Figure 11
Your Model 880 hose cart is now ready to use.
Attach the end of the leader hose to a water
source.
Note: If you have trouble with the swivel turning and kinking the leader hose, try
spraying a silicone spray inside to lubricate the O-rings. The O-rings located
inside the swivel may be dry. You can reach the O-rings by taking off the retaining
clip or spraying inside the opening of the swivel.
• DO NOT leave water running through the hose reel
unsupervised.
• DO NOT expose the reel to freezing temperatures with water
remaining in the unit.
• Turn the water off after each use.
G
B
G
E
P
C
P
D
L
Q
CART ASSEMBLY
NOTE: DO NOT use a compressor while inflating the tires;
hand pump only. 30 PSI maximum.