Longshine D945GSEJT - Manual (Page 32)

Intel Desktop Board D945GSEJT Product Guide
32
To remove an SO-DIMM from the socket, gently spread the socket’s retention arms as
shown in Figure 7 to disengage them from the SO-DIMM.
Figure 7. Removing System Memory
Connecting SATA Drives
Intel Desktop Board D945GSEJT supports two SATA drives with two data connectors.
The board ships with an in-line power cable that provides:
• a right-angled female-gender 1 x 4 connector for low-profile board connectivity
• a 15-pin SATA power connector for SATA drive power
• a female-gender 1 x 4 connector for system component power flexibility
To connect a SATA drive to the Desktop Board:
1. Observe the precautions in "Before You Begin" on page 27.
2. Attach one end of the SATA data cable to a SATA connector on the board
(Figure 8, A).
3. Attach the other end of the SATA data cable to the SATA drive (Figure 8, B).
4. Attach the right-angled 4-pin power connector on the power cable to the 4-pin
connector on the Desktop Board (Figure 8, C).
5. Attach the SATA power connector (Figure 8, D) on the power cable to the mating
connector on a SATA drive.