Luma Comfort IM200SS Manual - Manual (Page 7)

7
Say Goodbye to Ugly Products
M
AKING
I
CE
1. Remove the water reservoir cover and pour clean drinking water into the
water reservoir. Keep the water level below the “FULL” water level mark.
Close the water reservoir cover to prevent foreign matter from entering
the reservoir.
Please Note: Do not pour water into the internal water tank located
underneath the ice basket. Doing so will affect the ice maker’s performance.
2. Plug the ice maker into a suitable electrical outlet. Press the ON/OFF
button on the control panel to begin the ice making cycle. The green
power indicator will turn on for 2 seconds and then flash for 3 seconds. It
will then be on continuously.
3. The ice making cycle lasts anywhere from 15 to 30 minutes, depending on
the ambient temperature. The ice making cycle will also take slightly
longer when using the appliance for the first time. The ice making time
may vary significantly if the unit is being used in extremely warm
temperatures, but this will not exceed 50 minutes.
4. To make thicker ice, plug in the unit, press and hold the ON/OFF button
for 5 seconds or longer, and then release it to start the unit. The ice
making cycle will take an additional 3 minutes, but the ice cubes will be
thicker.
5. While the ice maker is on, periodically verify the water level in the
reservoir. If there is not enough water in the reservoir, the ice maker will
automatically stop, and the ADD WATER indicator light will turn on.