Make Noise STO User Manual
Page 3
Installation:
The Make Noise STO is an electronic signal generator requiring 30mA of +12V and 30ma of
-12V regulated power and properly formatted distribution receptacle to operate. It is designed
to be used within the euro format modular synthesizer system.
Go to
http://www.doepfer.de/a100_man/a100t_e.htm
for the details of this format.
To install, find 8HP of space in your euro-rack synthesizer system, confirm proper installation
of included power cable on backside of module (see picture below), plug the 16pin end
power cable into the euro-rack style power distribution board, minding the polarity so that the
RED stripe on the cable is oriented to the NEGATIVE 12 volt supply line. This is USUALLY at
the bottom.
Please refer to your case manufacturers’ specifications for location of the negative supply.
Proper installation of included power cable on module.
Please note the RED BAND.