Make Noise STO - Manual (Page 5)

STO Panel Controls
1. Variable Shape Waveform OUT: 10Vpp
2. Sub-Oscillator OUT: 12Vpp
3. Sine Waveform OUT: 10Vpp
4. Coarse Tune panel control: 9 octave range 8hz-4khz
5. 1V/ Octave Scale Trimmer (see calibration procedure)
6. Fine Tune panel control: +/-2.5 semi-tone range
7. Linear FM Level: uni-polar attenuator for Linear FM input
8. Linear FM INput: AC coupled, 10V range
9. Variable SHAPE: Ripples Even and Odd harmonics. With nothing patched to Variable
SHAPE CV IN, works as standard panel control. With Signal Patched to Variable
SHAPE CV IN, works as an attenuator for that signal.
10. Variable SHAPE CV IN: Direct Coupled uni-polar control signal input, range 0V to +8V
11. Expo INput: Exponential frequency control input. Bi-polar, 10V range
12. 1V/ Octave control INput: bi-polar pitch control, optimal range +/-5V
13. S-Gate: Resets and turns Sub-Oscillator ON at Gate HIGH, turns OFF at Gate LOW.
Just about any signal that exceeds 1V will work here.
14 SYNC: Resets Oscillator Core. Just about any 10Vpp audio rate signal will work here.
1 2 3
4
5
66
7
8
9
14
10
11 12 13