MF Digital OptiEC - Manual (Page 2)

IF YOU PURCHASED A PRINT STATION – SKIP THIS PAGE
Installing the Firewire Adapter Card
One and two drive ScribeECs require one
IEEE-1394 card. Four drive systems require
two IEEE-1394 cards.
1. Shut down the PC.
2. Turn the PC’s power off.
3. Unplug the PC.
4. Remove the PC’s cover as
indicated in the PC’s manual.
(fig. 2) (fig. 1)
You should never attempt to service a unit without ensuring proper anti-static protection. The
use of a grounding strap, or other such grounding device, is advised. In addition, the internal
configuration of your computer may be different from the computer pictured below.
Note:
5. Locate an empty PCI slot, as
seen in (fig.1).
6. Install the firewire adapter card (fig. 2).
Installing the Drive Bay
1. Place the drive bay onto the base unit as seen in (fig. 1).
2. Position the drive bay so that the front right corner sits over the dotted line (fig. 2). Proper position is
shown in (fig. 3).
(fig.1)
Page 2
(fig. 2) (fig. 3)