Compaq 230934-002 - Manual (Page 74)

MSA Fabric Switch 6 Management Utility
Modular SAN Array Fabric Switch 6 User Guide 3-39
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: d-ch3 MSA Fabric Switch 6 Management Utility.doc
Codename: Millebourne Part Number: 230934-002 Last Saved On: 7/17/02 7:52 AM
Network Tab
The Network window is accessed by clicking the “Network” tab of the System
Information display. It consists of the following two panels:
• IP Configuration
• SNMP Trap Management Stations
NOTE: The System Information - Network Tab page will not function properly without a valid
gateway address. If you are using the default gateway address (0.0.0.0) or an invalid gateway
address, you will need to change the address to a valid one. To check the gateway address on
your system using the CLI, see the section titled “NetCfg”. To change the gateway address
using the CLI, see the section titled “Setting the Gateway Address.”
IP Configuration This panel, as shown in the following figure, displays all of the IP
networking parameters that were set on the Fabric Switch 6 using the serial interface.
Figure 3-27: Network tab