MOOER VEM Box - Manual (Page 18)

Play/Stop loop
Note: The loop data will be remain even though you exit the loop mode, it will
be lost after power off or deleting operation.
17
05
Loop Functions
When recording ( is flashing on the LED display), press [PATCH+]
footswitch to stop playing and recording, LED display will turn to show
, press [PATCH+] footswitch again to start playback.
Exit Loop mode
When in Loop mode, hold down [PATCH –] and [PATCH +] footswitches
together longer than 2 seconds to exit loop function.
06
Selecting effects and Patch in Loop mode
When in Loop mode, you can select patches and adjust effects as well.
Set the Module Selector to [PATCH] module, you can select patches by
07
rotating [VALUE] knob. When adjusting effects in loop mode, the
parameters's value shown in LED display will last flashing, moreover, the
LED will return to indicate loop function if there is no operation in 3
Note: When selecting patches or adjusting effects in Loop mode, any operation
of Loop function will turned the LED display to indicate loop information at
once.
Note: In Loop mode, store function can not be operated.
seconds.
When loop is at stop status (LED display shows ), press [PATCH+]
footswitch to start loop playing (if there is no loop data, playback can not
be executed).
When the loop is playing ( is flashing on the LED display), press
[PATCH+] footswitch to stop playback, LED display will show .