Mapping screwdriver functions, Disabling the push-to-start function – Chicago Pneumatic SD25 User Manual
Page 23
Advertising
User’s Manual
December 2005
Page 15
Mapping Screwdriver Functions
This section describes how VS is used to map screwdriver functions to the buttons and switches on
the screwdriver. You can also use VS to change the default mapping. To do this, refer to the Visual
Supervisor User s Guide (part number 39-30-34823).
Disabling the Push-to-Start Function
Typically, to start a fastening cycle when the push-to-start function on a handheld screwdriver is
disabled:
•
Press the throttle/trigger lever to start the fastening cycle.
•
Release the throttle/trigger lever to stop the fastening cycle.
Advertising