Muse Research UniWire manual supplement - Manual (Page 21)

UniWireManualSupplement 2 MuseResearch,Inc.
The following are basic instructions. See your host sequencer’s documentation to learn, specifically, how to
route audio/midi data and instantiate/edit plugins:
 ConnectaudioandMIDIcablestoReceptor.
2 ConnectacrossoverEthernetcablebetweenReceptorandyourhostcomputeror,ifusingmultiple
Ethernetdevices,connectastandardEthernetcablebetweenReceptorandyourhostcomputer’sEthernet
Router/Switcher.
3 Ifpossible,connectaS/PDIFcablebetweenReceptorandyourhostcomputer.Mostaudiocardsand
somecomputershavebuilt-inS/PDIFconnectors.Synchronizethetwodeviceseitherby)setting
Receptor’s
Sample Clock SourcetouseS/PDIFSync(meaningyourcomputeristhemasterclock),or
2)settingyourcomputertosynctoincomingS/PDIFfromReceptor.Withoutsynchronization,youmay
experienceoccasionalglitchesduringaudioplaybacksince,eventhoughyou’reusingReceptorforallyour
audioinsandouts,yourhostsequencerisstillgettingitstimingfromthecomputer’sbuilt-inaudio.
3 OnReceptor,makesureUniWiremodeisturnedon.
On the front panel, press the SETUP button, rotate the top display knob to select the UniWire option, then rotate the
bottom display knob to select Enabled.
On the graphical interface, press the Setup Tab and, in the UniWire section, check the Enable UniWire option.
4 EnableReceptor’sbuilt-inAudio+MIDII/O.
On the front panel, press the SETUP button, rotate the top display knob to select the UniWire Receptr I/O
option, then rotate the bottom display knob to select Audio+MIDI Enabled.
On the graphical interface, Press the Setup Tab and, in the UniWire section, check the Enable Receptor Audio+MIDI
I/O option.
Note that Receptor does not output MIDI data over UniWire. It receives MIDI data from your host computer
and it both sends and receives audio data, as discussed in the following sections:
To send audio from Receptor to your host sequencer over UniWire
If you want to send any audio received by Receptor to your host sequencer (for recording or for additional
effects processing by your host sequencer), you would do the following:
1 In Receptor, configure a channel with the Source set to the desired audio input.
2 In your host sequencer, instantiate a UniWire˛FX plugin on an audio track.