Muse Research UniWire manual supplement - Manual (Page 26)

UniWireManualSupplement 26 MuseResearch,Inc.
Cubase Uses Receptor as an External UniWire Instrument
The following describes how to use UniWire to make Receptor act as an external instrument within
Cubase˛SX3:
1 Before beginning, make sure UniWire is enabled on Receptor.
To do this from Receptor’s graphical interface, click the SETUP tab and check the Enable UniWire option in the new
UNIWIRE section in Setup View.
To do this from Receptor’s front panel, press the SETUP button and rotate the top display knob until the top line shows
the “UniWire” option, then rotate the bottom knob to select Enabled.
2 InCubase,createanewMIDITrackbychoosing Project>Add Track>MIDI.
3 Choose Devices>VST Instrumentand,inablankinstrumentselectorwithintheresultingwindow,choose
UniWire InstrumentfromtheMusefolder.
4 InCubase’sTrackInspector,assignthedesiredMIDIInputtothistrack;assignthepreviouslyinstantiated
UniWireInstrumentpluginastheMIDIout,andsetaMIDIchannel.
UniWireVSTInstrumentAssigned
ClicktoopenUniWireplugin
MIDIChannel
5 Clickthe“OpenDevice”icon(totheleftoftheMIDIchannelsetting)toopenthegraphicaleditorforthe
UniWireplugin.