MUTEC MC-1.1+ - Manual (Page 10)

\\\\\\\\\\\\\
C O N T R O L E L E M E N T S C O N T R O L E L E M E N T S C O N T R O L E L E M E N T S
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > 88
Manual SDs-01 E 3.2.2003 18:26 Uhr Seite 6
3 AES/EBU IN
This input receives a balanced AES3 digital audio or AES11 blank frame
signal compliant with AES 3–1992 (R1997) and AES 11–1997/2003. The input
impedance is 110 Ω (XLR connector, female).
4 S/P-DIF IN
These two S/P-DIF inputs, available as optical (»OP«) and coaxial (»CO«)
interfaces, can receive an optical S/P-DIF and an unbalanced electrical S/P-DIF
digital audio or blank frame signal in compliance with the IEC 60958 stand-
ard. The coaxial interface impedance is 75 Ω. (cinch connector), the optical
interface offers a Toshiba Toslink
TM connector, EIAJ standard.
5 AES3id IN
This receives an AES3id digital audio or AES11id blank frame signal in com-
pliance with the AES3id–2001 standard. The impedance of both connector
is 75 Ω (BNC connectors, female).
6 MAINS IN, Power Switch + Power Inlet
This is the main switch for switching the device on and off. Be sure to
make all connections (especially the supplied power cable) properly before
turning on the switch. Heed the SAFETY INSTRUCTIONS at the beginning of
this manual.
Connect the supplied power cable here. Make sure that the power switch
is turned off before connecting the power cable to this inlet and to the
power outlet. Line voltages within the range of 90…260 V with a frequency
of 50 or 60 Hz can be applied. The internal power supply will automatically
make all necessary adjustments.
10