Mytek Digital Stereo 96 DAC (VER.8/sep 2010) - Manual (Page 11)

10
Rack Mount Shelf
The Stereo96 DAC is 1/3 rack space wide and 1U tall.
Mytek provides a 1U rack mount shelf as an accessory to mount up to 3 of
the 1/3 rack units. The units are attached to the shelf with a small screw
connecting the shelf to the bottom through a threaded hole on the bottom of
the unit.
When mounting the unit to the rack, you must follow these procedures to
ensure that you do not cause any damage to your unit:
1. Remove the rubber feet. If the feet are left on then you run the risk
of bending the chassis and/or the circuit board.
2. Use the supplied 1/4” 440 threaded screw only. Any longer and you
can cause permanent damage to the circuit board!
If you want to leave the rubber feet on then you have to be extra careful to
not overtighten the screw past the point of bending the chassis. 1/4” will
possibly work with the feet on but 3/8” 440 thread is recommended, although
there is a higher risk of circuit board damage with a longer screw.