Mytek Digital Stereo 96 DAC (VER.8/sep 2010) - Manual (Page 4)

Output volume knob sets the output
volume with range from mute to max.
This is factory default. The knob can
be disabled with internal jumpers.
Additionally internal precision 10 turn
trimpots can be used to set the overall
gain of the output. Refer to "Internal
jumper settings" for details.
Input selection. Selects
which digital input source
to use for conversion to
analog.
Peak meter in -
dBFS. The red LED
marked "0"
corresponds to 1
sample overload. Hi-Fidelity, high drive
headphone out can drive
any type of headphones
with ultimate fidelity. It is
able to provide up to 1 Amp
of instant current drive. The
headphone out is the same
as XLR and it's always
routed through the knob. When converter is synced to input its behaviour is
similar to real world situtation with some but not
full immunity to jitter. Superlock Mode uses stable
internal clock and provides the best clock stability
(10ps) and thus the best conversion. In
Superlock(tm) mode any signal is upsampled to
full 24 bit, 192k resolution and subsequently
converted to analog. The two modes are provided
for comparison reasons ie. real world vs. ideal
sound with no jitter.
Line power is 115VAC/50/60Hz
(factory default) or
230VAC/50/60Hz switchable by
internal switch accessible after
removing the top cover. 1 Amp
slow blow 20mm fuse is also
accessible under the cover.
Optical Toslink input can accept
both SPDIF and AES formats.
SPDIF format allows to interface
with Mac computers, including
Powermac laptops (up to 96kHz).
Analog outputs are +4dB balanced. They can also
be used to drive unbalanced inputs (pin1 GND, pin
2 signal, pin 3 NC). If the signal is too hot for
consumer unbalanced input, turn down the gain
using internal precision gain trimpots. AES/EBU SPDIF
"single wire" mode for all sampling
frequencies.
, 1, SPDIF2 and OPTICAL inputs
are seamlessly switchable on the front panel. This
switch can be used as input selector for 4 sources.
They operate in
Inputs accept signal up to 96k.
3
110/220VAC
SWITCH AND FUSE INSIDE
AES IN OUT L OUT R
SPDIF
IN1
SPDIF
IN2
WWW.MYTEKDIGITAL.COM
TOSLINK
IN
Quick Start