Sway bar adjustment – Neuspeed 25.02.19.4 User Manual
Page 2
Left hand (driver’s) side shown. Some OE components have been removed for clarity.
3. To remove sway bar, drop passenger side down first and slide out toward passenger side.
4. Coat inside of polyurethane bushings with special NEUSPEED supplied grease and install on each side of
sway bar. Install sway bar clamps over bushings.
5. Install supplied frame support bracket to sub-frame. Align upper clearance hole on bracket with upper
clearance hole on subframe and install M8 bolt through bracket, subframe, M8 washer and nyloc nut.
Position tubular brace and bracket over lower hole and insert flanged bolt through brace, bracket, subframe
and M8 washer. Install nyloc nut but do not tighten fasteners completely.
6. Install bolts through sway bar clamp, vehicle mount and support bracket. Fasten with nyloc nuts and torque
to 34Nm (25 lbf ft.).
7. Now torque fasteners securing bracket to sub-frame and lower brace to bracket to 34Nm (25 lbf ft.).
8. Repeat steps 5 through 7 for opposite side.
SWAY BAR ADJUSTMENT:
9. Your NEUSPEED sway bar has 3 different roll stiffness settings. Install the end link in the hole closest to the
end of the bar for the softest setting or further away for maximum stiffness. Placing links in different holes
will yield the medium setting. Install end link nuts and torque to 47Nm (35 lbf ft.).
10. Carefully double-check complete installation, and TEST DRIVE CAREFULLY!
Copyright 2001, NEUSPEED
®
. All rights reserved. Reproduction in whole or in part prohibited.
DOC.25.02.19.4 Rev. 03.27.03
NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com & http://www.apsoutlet.com