Neuspeed 62.10.71 - Manual (Page 3)

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com
11. With a hammer and chisel, gently remove key
from crankshaft pulley.
12. Remove any burs from key.
13. Install key in keyway of supplied crankshaft
pulley and gently tap into position.
14. Position pulley on crankshaft and align key to
keyway. Gently press pulley onto shaft. If pulley
does not slide on shaft easily, remove and check for
burs or corrosion. If any burs or corrosion exists,
remove as necessary. Use of excessive force to
install the pulley will damage both the pulley and
the crankshaft and will void warranty. Install
supplied bolt and torque to 100Nm (74ft-lb.) plus an
additional ¼ turn using VW tool Counter Holder
(T10069) and 27 mm socket
.
15. Install power steering pump pulley and torque
bolts to 20Nm (15ft-lb.)
16. Install supplied alternator pulley on alternator
shaft followed by the washer and nut. Using a 24mm
wrench on alternator pulley, torque nut (24mm) to
65Nm (48 ft.-lb.)