Neuspeed 65.10.85 - Manual (Page 2)

NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •
[email protected] • www.neuspeed.com
11. Install NEUSPEED intake pipe onto turbo
inlet with #44 clamp supplied and
attach rubber isolator mount to ear on
end of cylinder head with M6x10mm
screw. Intake pipe should be positioned
at an upward angle toward brake fluid
reservoir for engine torque clearance,
now tighten hose clamp and M6 screw.
NOTE: When tightening isolator
mount, do not over tighten – rubber
isolator should not have any
twisting force applied to it.
12. Install MAF sensor (screw holes match-
up one direction only) and tighten with
(2) M4x8mm Philips head screws
supplied. Attach electrical connector.
13. Reconnect Diverter Valve hose.
14. Move MAF sensor wire holder on
coolant hose down to next bend on
hose.
15. Install filter onto end of intake pipe.
16. Double check installation and tightness
of all connections. PLEASE TEST DRIVE
CAREFULLY.
Copyright 2012, NEUSPEED ® . All rights reserved.
Reproduction in whole or in part prohibited. DOC.65.10.85
Rev. 05.18.12