Neuspeed 65.10.84 User Manual
Page 2
NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •
•
www.neuspeed.com
14. Mount MAF sensor to SS P-Flo bracket
using supplied M6x16mm screws and
lock nuts, then tighten.
15. Install NEUSPEED P-Flo bracket onto
rubber grommet mount and rubber
isolator.
16. Install and tighten acorn nut using an
11mm wrench.
17. Install intake pipe with port closer to the
front and positioned at 1 o’clock.
18. Install 90° silicone hose onto MAF.
NOTE: Use silicone spray to ease install.
Slide the two supplied #48 hose clamps
onto silicone hose and then connect to
intake pipe. Now position clamps and
tighten.
19. Connect vacuum line to port on
NEUSPEED intake pipe.
20. Connect
supplied
MAF
harness
extension.
21. Move MAF wire harness support clip
down next to vacuum canister.
22. Install rubber strip on top-edge of P-Flo
bracket.
23. For extra protection, slide coolant hose
protector sleeve just under P-Flo
bracket.
24. Attach and tighten NEUSPEED filter.
Position NEUSPEED logo on end of filter
horizontally.
25. Double-check complete installation.
Copyright 2013, NEUSPEED
®
All rights reserved. Reproduction in whole or
in part prohibited.
DOC. 65.10.84 Rev. 07.25.13