NORAC UC4+BC+NT4 - Manual (Page 25)

21
Figure 22: Access Plates
Configurations
6. Route the four metri-pack connectors
on cable C16 to the rear of the sprayer,
in the vicinity of the main lift valve
block.
7. Disconnect the sprayer’s metri-pack
tower labeled MM13 and connect it to
the shroud from cable C16 labeled
“MAIN UP”.
8. Connect the tower on cable C16
labeled “MAIN UP” to the sprayer
solenoid that was disconnected in
STEP 7.
9. Disconnect the sprayer’s metri-pack
connector labeled MM14 and connect it
to the shroud on cable C16 labeled
“MAIN DOWN”.
10. Connect the tower on cable C16
labeled “MAIN DOWN” to the sprayer
solenoid that was disconnected in
STEP 9.
Figure 23: Nitro Main Section Valve
Connector
Figure 24: Main Lift Wiring Connections
Main Lift
Connectors MM13