NORAC UC5-BC-JD06 User Manual
Page 23
Advertising
20
Figure 23: Valve Module Bracket Installation
5. With the valve module securely mounted to the valve block, connect the valve cables (C10),
to the valve coils. Insert the 2-pin plugs (P01) into the unused 2-pin connectors on the
valve module.
6. Connect the temperature probe to the valve block using the supplied 3/8” x 1/2” hex bolt.
7. Connect the valve module CANbus to cable C01 from the control module. Route cable
C02 from the other CANbus connector to the input module.
Figure 24: Valve Module - Valve Coil Connections
Tank Port
Pressure Port
Sense Port
Left Tilt Ports
Right Tilt Ports
Advertising