NORAC UC5-BC-JD06 - Manual (Page 28)

25
6. Remove the plug from the Sense Line Bleed port. Location is shown in Figure 30. Gently
tap the plug with a hammer to loosen it before attempting to remove it.
7. Remove the Sense Line Bleed Orifice and discard. Figure 30.
8. Install the setscrew (F11) into the Sense Line Bleed Orifice location. Ensure the setscrew
is threaded entirely into the hole and tightened to 35-40 in-lbs to ensure a tight seal.
9. Reinstall the plug and tighten to 35-40 in-lbs.
Figure 30: Load Sense Bleed Orifice Location on Top of Block