NORAC UC5-BC-HG07 - Manual (Page 23)

20
10. Connect the 2-pin Deutsch plug labeled “SOL 6” on C10 to the Hagie Main Down
connector.
11. Route the 12-pin Deutsch connector on C10 toward the input module.
12. Insert the 2-pin plug (P01) into the unused 2-pin connector on output 8.
13. Connect cable C11 to output 7 on the valve module. Route the cable to the Hagie valve
block. Disconnect the Lock valve and insert the connectors from cable C11.
14. Connect the temperature probe to the valve block using the supplied 3/8” x 1/2” hex bolt.
Figure 19: Valve Module and Input Module Mounting